We will dispatch our certified technician(s) to your home or office to resolve your.

Our technicians are trained to professionally perform water damage restoration.

Dalworth Restoration is a Full-Service fire, water, storm damage and mold restoration company serving the greater DFW area.

For professional drywall water damage restoration and reconstruction, call your local PuroClean office.

That way, you will reduce further damage to your homes structure and contents, such as flooring, furniture, ceiling, and drywall (gypsum board).

Depending on the type of flood and where water has intruded, the drywall should be either entirely or partially replaced.

Thus, when dealing with drywall ceiling water damage, your personal safety may be at risk.

In this case, have your propertys structure assessed by a professional restoration company.

This kind of job involves safety issues and biohazard cleanup services that are often beyond the capacity of typical homeowners.

The longer the water sits, the greater the damage to your drywall will be.

Also, remove wet carpet and padding, or at least pull it back to allow the floor to air out.

Additionally, remove non-affected electrical outlets before tearing out wall material.

If the water level was less than two-and-a-half feet, remove the wall material to a height of four feet.

If the water level was greater than two-and-a-half feet, remove the wall material to a height of eight feet or the ceiling junction, whichever is higher.

But if its just damp and the water source was clean (e.g.,.

Depending on the extent of the water damage, you may also need to remove damaged wall studs, flooring, cabinets, and ceilings.

To make that easier, knock a small hole in the damaged drywall using a hammer.

If its foam plastic insulation, you can leave it in place and allow it to dry.

Use high-efficiency blowers and dehumidifiers and open the windows and doors.

Use fans to increase air flow behind walls and leave them running for at least two days so the studs and flooring can completely dry.

To remove severe odors, use an ozone machine and leave it running for at least eight hours.

First, measure the size of the hole to help you know how much to cut out from a new sheet of drywall.

Put four drywall clips around the hole and secure each one with a drywall screw.

Finally, sand the area several times for a smooth wall surface.

First, make sure that the joint compound is completely dry as it would contain a lot of moisture.

After that, paint the entire wall to ensure the color is uniform throughout.

Everything needs to be done fast using the right techniques and tools.

Replace Water Dmg Wall